CPL - Chalmers Publication Library
| Utbildning | Forskning | Styrkeområden | Om Chalmers | In English In English Ej inloggad.

Investigation of NiO-based mixed oxides in a 300-W chemical-looping combustor

Carl Linderholm (Institutionen för energi och miljö, Energiteknik) ; Erik Jerndal (Institutionen för kemi- och bioteknik, Oorganisk miljökemi) ; Tobias Mattisson (Institutionen för energi och miljö, Energiteknik) ; Anders Lyngfelt (Institutionen för energi och miljö, Energiteknik)
Chemical Engineering Research & Design (0263-8762 ). Vol. 88 (2010), 5-6A, p. 661-672.
[Artikel, refereegranskad vetenskaplig]

Chemical-looping combustion, CLC, is a novel combustion concept with inherent separation of CO2. This study evaluates the performance of spray-dried nickel-based oxygen carrier particles prepared from commercially available materials. The possibility to optimize the methane conversion while retaining the oxygen transport capacity by mixing different NiO-based oxygen carriers was evaluated and results showed that such optimization was indeed possible. Experiments were carried out in a batch reactor as well as in a continuous 300-W unit. Experiments in the batch reactor evaluated the performance of two different spray-dried particles, individually and mixed, at two different temperatures, 850°C and 950°C. The reference particle, referred to as N-VITO in this study, contained only NiO and NiAl2O4 while the other spray-dried particle was similar to the reference but contained a small amount of MgO as additive in the starting material. It was found that the reference particle had good oxygen-transport characteristics, but that methane conversion left room for improvement. The particle with MgO addition, on the other hand, showed excellent methane conversion, but poor oxygen transport capability, especially at the lower temperature. The 50/50mass-mixture of the two particles resulted in a potent oxygen-carrier batch with the desired qualities. Three experimental series were conducted in the 300-W CLC-unit; (i) using only the reference particle, (ii) using a mixture of the reference particle and the particle with MgO-addition, and (iii) using the previous mixed oxide system together with a small quantity of a high-surface impregnated oxygen-carrier based on NiO and Al2O3. It is shown that the methane conversion to CO2 is dependent primarily on the solids flux in the reactor system, but also on the temperature in the fuel reactor. Results showed that the operation was more stable and that it was possible to obtain better fuel conversion when the mixtures of two or three different oxygen carrier particles were used. With these mixtures, the methane fraction could be brought down to < 0.1% while still maintaining a low CO fraction.

Nyckelord: chemical-looping combustion, oxygen carrier, nickel oxide, fluidized bed



Denna post skapades 2009-01-26. Senast ändrad 2016-08-22.
CPL Pubid: 88966

 

Läs direkt!


Länk till annan sajt (kan kräva inloggning)


Institutioner (Chalmers)

Institutionen för energi och miljö, Energiteknik
Institutionen för kemi- och bioteknik, Oorganisk miljökemi (2005-2014)

Ämnesområden

Energiteknik

Chalmers infrastruktur

Relaterade publikationer

Denna publikation ingår i:


CO2 Capture using Chemical-Looping Combustion – Operational Experience with Gaseous and Solid Fuels