CPL - Chalmers Publication Library
| Utbildning | Forskning | Styrkeområden | Om Chalmers | In English In English Ej inloggad.

Investigations regarding the wet decontamination of fluorescent lamp waste using iodine in potassium iodide solutions

Cristian Tunsu (Institutionen för kemi och kemiteknik, Industriell materialåtervinning) ; Christian Ekberg (Institutionen för kemi och kemiteknik, Industriell materialåtervinning) ; Mark Foreman (Institutionen för kemi och kemiteknik, Kärnkemi) ; Teodora Retegan (Institutionen för kemi och kemiteknik, Kärnkemi)
Waste Management (0956-053X). Vol. 36 (2015), p. 289-296.
[Artikel, refereegranskad vetenskaplig]

With the rising popularity of fluorescent lighting, simple and efficient methods for the decontamination of discarded lamps are needed. Due to their mercury content end-of-life fluorescent lamps are classified as hazardous waste, requiring special treatment for disposal. A simple wet-based decontamination process is required, especially for streams where thermal desorption, a commonly used but energy demanding method, cannot be applied. In this study the potential of a wet-based process using iodine in potassium iodide solution was studied for the recovery of mercury from fluorescent lamp waste. The influence of the leaching agent's concentration and solid/liquid ratio on the decontamination efficiency was investigated. The leaching behaviour of mercury was studied over time, as well as its recovery from the obtained leachates by means of anion exchange, reduction, and solvent extraction. Dissolution of more than 90% of the contained mercury was achieved using 0.025/0.05 M I-2/KI solution at 21 degrees C for two hours. The efficiency of the process increased with an increase in leachant concentration. 97.3 +/- 0.6% of the mercury contained was dissolved at 21 degrees C, in two hours, using a 0.25/0.5 M I-2/KI solution and a solid to liquid ratio of 10% w/v. Iodine and mercury can be efficiently removed from the leachates using Dowex 1X8 anion exchange resin or reducing agents such as sodium hydrosulphite, allowing the disposal of the obtained solution as non-hazardous industrial wastewater. The extractant CyMe4BTBP showed good removal of mercury, with an extraction efficiency of 97.5 +/- 0.7% being achieved in a single stage. Better removal of mercury was achieved in a single stage using the extractants Cyanex 302 and Cyanex 923 in kerosene, respectively.

Nyckelord: Fluorescent lamp waste,Mercury, Iodine, Thermal-Desorption Technology, Acidic Chloride Solutions, Rare-Earth-Metals, Recovery, Yttrium, Spectrometry, Extraction, Salts



Denna post skapades 2015-03-16. Senast ändrad 2015-11-05.
CPL Pubid: 213879

 

Läs direkt!


Länk till annan sajt (kan kräva inloggning)