CPL - Chalmers Publication Library
| Utbildning | Forskning | Styrkeområden | Om Chalmers | In English In English Ej inloggad.

Detection and 3-D positioning of small defects using digital radiography, 3-D point reconstruction, and tracking

Erik Lindgren (Institutionen för material- och tillverkningsteknik, Avancerad oförstörande provning)
Göteborg : Chalmers University of Technology, 2015. ISBN: 978-91-7597-137-7.- 127 s.
[Doktorsavhandling]

The weight and quality concerned aero industry is constantly trying to decrease the excess material in their components. With decreased weight the fuel consumption can be lowered and the negative environmental effects from aviation decreased. One possible way to remove excess material, for example in gas turbine engine components, without decreasing safety is to increase the capability and reliability of the quality control. Such quality control improvements would facilitate less uncertain fatigue life predictions, which would then support cutting some of the excess material in the component without lowering the safety factors. When laser welding light weight materials, for example titanium based alloys, small submillimeter pore defects occasionally forms in clusters. Due to their small sizes, less than some 0.2 mm, as individuals they are believed to have low impact on the component fatigue life. However, existing fatigue life models predict that pore defects with small interspacings should instead be considered as a single larger pore, which might then have a higher impact on the fatigue life. These submillimeter pore 3-D interspacings is an example of increased nondestructive evaluation capability of value when predicting the fatigue life of manufactured components. The aim of this work has been to assess the applicability of using digital radiography and 3-D point reconstruction algorithms as the at the manufacturing in-line quantitative nondestructive evaluation to detect, size, and 3-D position small submillimeter pores. There are six papers included in this thesis. The first paper describes a simple mathematical model used to produce realistic synthetic radiographs representing the radiographic inspection. The model is extended in the second paper with an improved X-ray detector model, spatial correlated quantum noise, and additional experimental comparison. In addition, the validity range of the presented model is explored. In the third paper, a 3-D point reconstruction algorithm based on tracking is derived, set up, and pre-evaluated utilizing synthetic radiographs, and experimentally verified on a weld sample. The fourth paper contains a high contrast-to-noise ratio experimental verification of the 3-D point reconstruction algorithm. In addition, a method and an algorithm to measure the radiographic setup geometry is derived and experimentally verified. In the fifth paper the detectability limitations in 3-D point reconstruction are explored in connection to component fatigue life models. In the sixth paper the capability of the 3-D point reconstruction algorithm is experimentally explored on a commercially available setup utilizing the radiographic magnification technique.

Nyckelord: X-ray Testing, Radiographic Testing, Nondestructive Evaluation, Multiple Hypothesis Tracking, Pore Defects, Laser Welded Titanium



Den här publikationen ingår i följande styrkeområden:

Läs mer om Chalmers styrkeområden  

Denna post skapades 2015-02-05.
CPL Pubid: 212187

 

Institutioner (Chalmers)

Institutionen för material- och tillverkningsteknik, Avancerad oförstörande provning

Ämnesområden

Materialvetenskap
Produktion
Transport
Materialteknik
Teknisk fysik

Chalmers infrastruktur

Examination

Datum: 2015-02-27
Tid: 10:00
Lokal: EA, Hörsalsvägen 11, Chalmers
Opponent: Professor Uwe Ewert

Ingår i serie

Doktorsavhandlingar vid Chalmers tekniska högskola. Ny serie 3818