CPL - Chalmers Publication Library
| Utbildning | Forskning | Styrkeområden | Om Chalmers | In English In English Ej inloggad.

Study On Wear Behaviors Of Ni3al/ Cr-Carbides Cladding Layer On High Strength Steel Substrate

Karin Gong (Institutionen för material- och tillverkningsteknik, Yt- och mikrostrukturteknik)
Advanced Materials Research (2014) Vol. Vol. 936 (2014), p. pp 1273-1282.
[Konferensbidrag, refereegranskat]

A cladding layer of Ni3Al matrix composite reinforced with 18 vol. % Cr-carbides was applied by using tungsten inert gas (TIG) welding process on high strength steel substrate. The filler metal as welding wire prepared by horizontal continuous casting process with a composition of Ni- 2.5C-30Cr-9Al-0.02B (in wt. %) is used. A bulk material of NAC-alloy composite with 18 vol. % Cr3C2-particles produced by Hot Isostatic Pressing (HIP) was also investigated as a reference material. The composition of NAC-alloy is Ni-9.87Al-11.63Fe-0.50Mn-0.50Ti-0.2B in weight percentage. The pin-on-disk (POD) tribometer tests were carried out at room temperature in dry sliding condition at a pressure of 2.83 MPa (20N). The results revealed that Ni3Al/ Cr-carbides cladded layer by TIG process improved wear properties significantly with very low values of the friction coefficient (0.13 ± 0.02) and the specific wear rate (0.162 x 10-5 mm3/N·m) as compared to the reference HIP processed composite with the friction coefficient (0.68 ± 0.02) and the specific wear rate (0.908 x10-5 mm3/N·m) under the same testing conditions.

Nyckelord: Friction coefficient; Specific wear rate; Intermetallics; Sliding wear; Cladding

Den här publikationen ingår i följande styrkeområden:

Läs mer om Chalmers styrkeområden  

Denna post skapades 2014-12-19. Senast ändrad 2014-12-19.
CPL Pubid: 208664


Läs direkt!

Lokal fulltext (fritt tillgänglig)

Institutioner (Chalmers)

Institutionen för material- och tillverkningsteknik, Yt- och mikrostrukturteknik (2005-2017)



Chalmers infrastruktur