CPL - Chalmers Publication Library
| Utbildning | Forskning | Styrkeområden | Om Chalmers | In English In English Ej inloggad.

Sea level time series and ocean tide analysis from multipath signals at five GPS sites in different parts of the world

Johan Löfgren (Institutionen för rymd- och geovetenskap, Rymdgeodesi och geodynamik) ; Rüdiger Haas (Institutionen för rymd- och geovetenskap, Rymdgeodesi och geodynamik) ; Hans-Georg Scherneck (Institutionen för rymd- och geovetenskap, Rymdgeodesi och geodynamik)
Journal of Geodynamics (0264-3707). Vol. 80 (2014), p. 66-80.
[Artikel, refereegranskad vetenskaplig]

We present sea level observations derived from the analysis of signal-to-noise ratio (SNR) data recorded by five coastal GPS stations. These stations are located in different regions around the world, both in the northern and in the southern hemisphere, in different multipath environments, from rural coastal areas to busy harbors, and experience different tidal ranges.

The recorded SNR data show periodic variations that originate from multipath, i.e. the interference of direct and reflected signals. The general assumption is that for satellite arcs facing the open sea, the rapid SNR variations are due to reflections off the sea surface. The SNR data recorded from these azimuth intervals were analyzed by spectral analysis with two methods: a standard analysis method assuming a static sea level during a satellite arc and an extended analysis method assuming a time dependent sea level during a satellite arc.

The GPS-derived sea level results are compared to sea level records from co-located traditional tide gauges, both in the time and in the frequency domain. The sea level time series are highly correlated with correlation coefficients to the order of 0.89–0.99. The root-mean-square (RMS) difference is 6.2 cm for the station with the lowest tidal range of 165 cm and 43 cm for the station with the highest tidal range of 772 cm. The relative accuracy, defined as the ratio of RMS and tidal range, is between 2.4% and 10.0% for all stations.

Comparing the standard analysis method and the extended analysis method, the results based on the extended analysis method agree better with the independent tide gauge records for the stations with a high tidal range. For the station with the highest tidal range (772 cm), the RMS is reduced by 47% when using the extended analysis method. Furthermore, the results also indicate that the standard analysis method, assuming a static sea level, can be used for stations with a tidal range of up to about 270 cm, without performing significantly worse than the extended analysis method.

Tidal amplitudes and phases are derived by harmonic analysis of the sea level records. Again, a high level of agreement is observed between the tide gauge and the GPS-derived results. Comparing the GPS-derived results, the results based on the extended analysis method show a higher degree of agreement with the traditional tide gauge results for stations with larger tidal ranges. Spectral analysis of the residuals after the harmonic analysis reveals remaining signal power at multiples of the draconitic day. This indicates that the observed SNR data are to some level disturbed by additional multipath signals, in particular for GPS stations that are located in harbors.

Nyckelord: GPS, Sea level, Signal-to-noise ratio, Multipath, Ocean tide analysis, Reflected signals, Tide gauge


There are supplementary data associated with this article.



Denna post skapades 2014-04-10. Senast ändrad 2016-05-24.
CPL Pubid: 196558

 

Läs direkt!

Lokal fulltext (fritt tillgänglig)

Länk till annan sajt (kan kräva inloggning)