CPL - Chalmers Publication Library
| Utbildning | Forskning | Styrkeområden | Om Chalmers | In English In English Ej inloggad.

Uncertainties and optimized sampling in surface roughness characterization

Bengt-Göran Rosén (Institutionen för material- och tillverkningsteknik, Tillverkningsteknik) ; J. Garnier
Wear (0043-1648). Vol. 271 (2011), 3-4, p. 610-615.
[Konferensbidrag, refereegranskat]

Usage of 3D roughness parameters measurements requires knowledge of uncertainty causes in order to design proper measurement procedures. Even on apparently homogeneous machined surfaces, large local variations in 3D roughness parameters have previously been reported. This paper introduces and tests a concept for optimized sampling based on local-, and global topography analysis, using measurements of the Sa parameter on a large machined component as a practical example. It is shown that more than 40 measurements of Sa may be needed to attain a stable value, but that choice of an appropriate sampling strategy may reduce this requirement considerably. The results point to a possible route to minimize required measurements and contribute to the development of the "best-practice" when using 3D surface structure metrology.

Nyckelord: Uncertainty, Optimized, Sampling, Topography, Honing



Denna post skapades 2011-08-11.
CPL Pubid: 144070

 

Läs direkt!


Länk till annan sajt (kan kräva inloggning)


Institutioner (Chalmers)

Institutionen för material- och tillverkningsteknik, Tillverkningsteknik

Ämnesområden

Materialteknik

Chalmers infrastruktur