CPL - Chalmers Publication Library
| Utbildning | Forskning | Styrkeområden | Om Chalmers | In English In English Ej inloggad.

Grain boundary microstructure and fatigue crack growth in Allvac 718Plus superalloy

Leif Viskari (Institutionen för teknisk fysik, Mikroskopi och mikroanalys) ; Yu Cao (Institutionen för material- och tillverkningsteknik, Yt- och mikrostrukturteknik) ; Mats Norell (Institutionen för material- och tillverkningsteknik, Yt- och mikrostrukturteknik) ; G. Sjoberg ; Krystyna Stiller (Institutionen för teknisk fysik, Mikroskopi och mikroanalys)
Materials Science and Engineering A - Structural Materials Properties Microstructure and Processing (0921-5093). Vol. 528 (2011), 6, p. 2570-2580.
[Artikel, refereegranskad vetenskaplig]

The correlation between grain boundary microstructure and fatigue crack growth with hold-times was investigated for two conditions of the superalloy Allvac 718Plus; a Standard condition with the recommended distribution of grain boundary phases and a Clean condition with virtually no grain boundary phases. Fatigue testing was performed at 704 degrees C using 10 Hz cyclic load with intermittent hold-times of 100 s at maximum tensile load. Microstructural characterization and fractography were conducted using scanning- and transmission electron microscopy techniques. Auger electron- and X-ray photoelectron spectroscopy techniques were used for oxide analyses on fracture surfaces. It was found that in the Standard condition crack growth is mostly transgranular for 10 Hz loading and intergranular for hold-times, while for the Clean condition crack growth is intergranular in both load modes. The lower hold-time crack growth rates in the Standard condition are attributed to grain boundary delta-phase precipitates. No effect of delta-phase was observed for 10 Hz cyclic loading crack growth rates. Two different types of oxides and oxide colours were found on the fracture surfaces in the Standard condition and could be correlated to the different loading modes. For cyclic loading a bright thin Cr-enriched oxide was dominate and for hold-times a dark and slightly thicker Nb-enriched oxide was dominant These oxide types could be related to the oxidation of delta-phase and the matrix respectively. The influence of delta-phase precipitates on crack propagation is discussed.

Nyckelord: Delta-phase, Fractography, Oxidation, Hold-time fatigue, Electron, microscopy, X-ray photoelectron spectroscopy, Auger electron spectroscopy



Den här publikationen ingår i följande styrkeområden:

Läs mer om Chalmers styrkeområden  

Denna post skapades 2011-03-17. Senast ändrad 2016-02-01.
CPL Pubid: 138067

 

Läs direkt!


Länk till annan sajt (kan kräva inloggning)


Institutioner (Chalmers)

Institutionen för teknisk fysik, Mikroskopi och mikroanalys (2005-2012)
Institutionen för material- och tillverkningsteknik, Yt- och mikrostrukturteknik (2005-2017)

Ämnesområden

Materialvetenskap
Materialteknik

Chalmers infrastruktur

Relaterade publikationer

Denna publikation ingår i:


Oxygen Induced High Temperature Crack Growth in Ni-base Superalloys