CPL - Chalmers Publication Library
| Utbildning | Forskning | Styrkeområden | Om Chalmers | In English In English Ej inloggad.

Development and Verification of Control Systems for Flexible Automation

Johan Richardsson (Institutionen för signaler och system, Automation)
Göteborg : Chalmers University of Technology, 2005.
[Licentiatavhandling]

Consumer product life-cycles are constantly shortening; the automotive industry is an illustrative example. As a consequence, the introduction of new products into the manufacturing system necessarily becomes more frequent. Inherently, this brings a performance reduction for the manufacturing system. The reduced performance is caused by a down-time and a ramp-up-time. During the down-time the mechanical equipment is rebuilt and the new control programs are debugged. During ramp-up there are a large number of errors mainly caused by mechanical devices not being properly adjusted, bugs in the control programs and operators not used to new procedures. Thus, in order to maintain the productivity level and to achieve full cost-efficiency both the down-time and the ramp-up time must be reduced. One way to reduce the down-time and the ramp-up time is to verify the control programs in offline mode. However, efficient and reliable offline verification requires some major improvements of the current development process of manufacturing systems. Information handling and development of control programs based on information reuse are the two most important improvement areas. The work presented in this thesis addresses three industrial problems, lack of tools for offline verification of control programs, lack of information reuse in the development process of a manufacturing system, and lack of operator support in error situations. The method proposed in this thesis provides results that solve the industrial problems without adding work to the development process. On the contrary, the amount of work will be reduced since the control program development will be automated and the time for debugging the control programs on the shop floor will be drastically reduced, due to the new mathematically based verification process. In the proposed method information from different tools in the development process of a manufacturing system is reused and processed by tools for verification and optimization. Then the control programs are generated by combining the processed information with a library of standardized software components.



Denna post skapades 2006-01-19.
CPL Pubid: 12220

 

Institutioner (Chalmers)

Institutionen för signaler och system, Automation

Ämnesområden

Elektroteknik

Chalmers infrastruktur

Examination

Datum: 2005-05-19
Tid:
Lokal:

Ingår i serie

R - Department of Signals and Systems, Chalmers University of Technology R015/2005