CPL - Chalmers Publication Library
| Utbildning | Forskning | Styrkeområden | Om Chalmers | In English In English Ej inloggad.

Fracture Characteristics of Austempered Spheroidal Graphite Aluminum Cast Irons

Masoud Zandira (Institutionen för material- och tillverkningsteknik) ; S. M. A. Boutorabi
Journal of Iron and Steel Research International (1006-706X). Vol. 17 (2010), 2, p. 31-35.
[Artikel, refereegranskad vetenskaplig]

The fracture characteristics of austempered spheroidal graphite aluminum cast iron had been investigated. The chemical content of the alloy was C3.2, Al2.2, Ni0.8 and Mg0.05 (in mass percent, %). Impact test samples were produced from keel blocks cast in CO2 molding process. The oversized impact samples were austenitized at 850 and 950 degrees C for 2 h followed by austempering at 300 and 400 degrees C for 30, 60, 120 and 180 min. The austempered samples were machined and tested at room temperature. The impact strength values for those samples austempered at 400 degrees C varied between 90 and 110J. Lower bainitic structures showed impact strength values of 22 to 50J. The fractures of the samples were examined using SEM. The results showed that the upper bainitic fracture revealed a honey Comb-like topography, which confirmed the ductile fracture behavior. The lower bainitic fractures of those samples austempered for short times revealed brittle fracture.

Nyckelord: austempering, fracture characteristic, aluminum cast iron, DUCTILE IRON, MICROSTRUCTURE, TOUGHNESS



Denna post skapades 2010-05-12.
CPL Pubid: 121561

 

Läs direkt!


Länk till annan sajt (kan kräva inloggning)


Institutioner (Chalmers)

Institutionen för material- och tillverkningsteknik

Ämnesområden

Materialteknik

Chalmers infrastruktur