CPL - Chalmers Publication Library
| Utbildning | Forskning | Styrkeområden | Om Chalmers | In English In English Ej inloggad.

Effect of Laminate Tapering on Strain Distribution in Adhesive Joints: Experimental Investigation

Reza Haghani (Institutionen för bygg- och miljöteknik, Konstruktionsteknik) ; Mohammad Al-Emrani (Institutionen för bygg- och miljöteknik, Konstruktionsteknik) ; Robert Kliger (Institutionen för bygg- och miljöteknik, Konstruktionsteknik)
Journal of Reinforced Plastics and Composites (0731-6844). Vol. 29 (2010), 7, p. 972-985.
[Artikel, refereegranskad vetenskaplig]

Strain distribution in adhesive joints with untapered and normal-tapered laminates has been investigated using an experimental method. An optic measurement system, ARAMIS, was used to monitor the strain field in the adhesive layer. The results indicated that normal tapering of the laminate did not affect the shear and principal strain components, but it increased the maximum peeling strain in the joint for the tapering length examined in this study. The strength and failure mode of joints were also studied. It was found that normal tapering of the laminate did not improve the strength of the joint in comparison to joints with untapered laminates. Failure took place at the steel-adhesive interface in both configurations.

Nyckelord: adhesive joint, shear, peeling, strain distribution, untapered, normal-tapered, single-lap joints, optimization, stresses, fillet, spew

Denna post skapades 2010-05-04. Senast ändrad 2015-03-30.
CPL Pubid: 121156


Läs direkt!

Länk till annan sajt (kan kräva inloggning)

Institutioner (Chalmers)

Institutionen för bygg- och miljöteknik, Konstruktionsteknik (2005-2017)



Chalmers infrastruktur